Aspect Restoration
Condos & Apartments

Metal cladding and flashing repair

Our Services

Metal cladding and flashing services we provide

Metal panels, flashings and parapet copings close off the edges and tops of a building and direct water away from the wall. They depend on sealed joints, sound fasteners and the right slope, and most leaks start where one of those has failed.

Aspect Restoration repairs and replaces metal panels, flashings, parapet caps and copings, reseals panel joints and replaces corroded fasteners and sub-framing. We work with your building's engineer, or can bring in our engineering partner, Apollo Building Group, for structural review and repair design.

  • Metal and composite panel repair and replacement
  • Parapet caps and copings
  • Window head, sill and through-wall flashings
  • Panel joint resealing
  • Fastener and sub-framing replacement
  • Membranes under copings and flashings
Mid-rise building with metal panel cladding and new windows
Aging Timeline

How metal cladding and flashing age over 40 years

Exterior Interior Water behind panel Water at window head Suite damage Wet wall cavity Rust streak New flashingswith end dams Metal panel Panel joint Head flashing Sill flashing Window Insulation Steel stud wall Schematic, not to scale
Year0

Sealed and draining

Sealant closes the joints between the metal panels, and flashings over and under the window carry water back out past the face.

Cost of waiting
Maintenance Targeted repair Capital project

These are typical failure patterns for Ontario's climate, shown for illustration. They are not a prediction for any specific building: materials, detailing and maintenance history can shift these timelines by years. Only a professional assessment can show where your building stands.

Repair Or Replace

Spot repairs or full replacement

We recommend spot repairs when only some joints, fasteners or sections are failing, and full replacement when the coping or cladding is failing across the building. Our assessment gives your board the scope for both options.

When spot repairs are enough

  • Failed sealant is limited to some panel joints or coping laps
  • A few fasteners are loose or missing
  • Leaks trace to one section of coping or flashing
  • The metal and its finish are sound

When full replacement is needed

  • Copings are flat, back-sloped or loose along the roof edge
  • Panels, girts or fasteners are corroded across the building
  • The finish is peeling or the metal is rusting through
  • Joints keep failing because the system relies on exposed sealant
Glass and panel facade of a high-rise building
FAQ

Frequently Asked Questions About Metal Cladding

Split or missing sealant at panel joints and coping laps, loose or backed-out fasteners, rust streaks on the face, copings that are loose or lifting, and leaks at the top floor or around windows.

Metal expands and contracts with heat and cold, which loosens fasteners and opens joints over time. Copings that are flat or slope away from the roof also send water toward the wall instead of off it.

Often the joints can be resealed and the fasteners replaced. Panels need replacing when the metal or its sub-framing has corroded, or the finish has failed.

A membrane over the top of the wall, so any water that gets past the coping joints stays out of the wall below.

It can. Loose copings, panels and roof edge metal can lift in high winds. Report loose or rattling metal to your property manager so it can be secured.

No. Cladding and coping work is done from the roof, swing stages or lifts. Residents receive written notice through the property manager before work reaches their area.

Have a question that isn't covered here? Ask us directly

Tell us about your project

Tower or home, anywhere from downtown Toronto to the far side of the province, send us the details and we will come back to you within one business day.

Get a Quote (647) 555-1234 Tenders & RFPs welcome · Buildings & homes